Home › ENGINE · 1GR-FE › CHARGING › GENERATOR

GENERATOR > INSPECTION

for Preparation Click here



1. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY


    B016374E07
  1. Using vernier calipers, measure the exposed brush length.

    Standard exposed brush length:
    10.5 mm (0.413 in.)

    Minimum exposed brush length:
    4.5 mm (0.177 in.)

    If the exposed brush length is less than minimum, replace the brush holder.



2. INSPECT GENERATOR ROTOR ASSEMBLY


    A075674E04
  1. Check the rotor open circuit.

    1. Using an ohmmeter, measure the resistance between the slip rings.

      Resistance:
      2.3 to 2.7 Ω at 20°C (68°F)

      If the resistance is not as specified, replace the rotor.



    A075675E04
  1. Check the rotor ground.

    1. Using an ohmmeter, check that there is no continuity between the slip ring and rotor.
      If there is continuity, replace the rotor.



  1. Inspect slip rings.

    1. Check that the slip rings are not rough or scored.
      If rough or scored, replace the rotor.



    2. A075676E11
    3. Using vernier calipers, measure the slip ring diameter.

      Standard diameter:
      14.2 to 14.4 (0.559 to 0.567 in.)

      Minimum diameter:
      14.0 mm (0.551 in.)

      If the diameter is less than minimum, replace the rotor.



3. INSPECT GENERATOR ROTOR BEARING


    A075677
  1. Check the bearing is not rough or worn.
    If necessary, replace the bearing.



4. REMOVE GENERATOR ROTOR BEARING


    A075678E08
  1. Using SST, remove the bearing cover (outside) and bearing.

    SST
    09820-00021  

    NOTICE:
    Be careful not to damage the fan.

  1. Remove the bearing cover (Inside).



5. INSTALL GENERATOR ROTOR BEARING


    A075679E06
  1. Place the rotor on the pulley.

  1. Install the bearing cover (Inside).

  1. Using SST and a press, press in a new bearing.

    SST
    09820-00031  



    A075680E08
  1. Using SST, push in the bearing cover (outside).

    SST
    09285-76010  



6. INSPECT GENERATOR DRIVE END FRAME BEARING


    A075681
  1. Check the bearing is not rough or worn.
    If necessary, replace the bearing.



7. REMOVE GENERATOR DRIVE END FRAME BEARING


    A075682
  1. Remove the 4 screws and retainer plate.



    A075683E02
  1. Using SST, tap out the bearing.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)



8. INSTALL GENERATOR DRIVE END FRAME BEARING


    A075684E02
  1. Using SST and a press, press in a new bearing.

    SST
    09950-60010   (09951-00470)
    09950-70010   (09951-07100)

  1. Install the retainer plate with the 4 screws.

    Torque:
    2.6 N*m{ 27 kgf*cm , 23 in.*lbf }