Home › ENGINE ยท 1GR-FE › CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR PULLEY
SST
09820-63010   (09820-06010, 09820-06020)

HINT:
SST 1-A and B
09820-06010
SST 2
09820-06020



    A075664E09
  1. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise with the specified torque.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Check that SST is secured to the rotor shaft.



    A075665E05
  1. Mount SST 2 in a vise.

  1. Insert SST 1-A and B into SST 2, and attach the pulley nut to SST 2.



    A075666E03
  1. To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.

    NOTICE:
    To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half turn.

  1. Remove the generator from SST 2.



    A075667E06
  1. Turn SST 1-B, and remove SST 1-A and B.

  1. Remove the pulley nut and pulley.



2. REMOVE GENERATOR REAR END COVER


    A075668E02
  1. Place the generator on the pulley.

  1. Remove the 3 nuts and rear end cover.



3. REMOVE TERMINAL INSULATOR


    A075669
  1. Remove the terminal insulator.



4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A075670
  1. Remove the plate seal.

  1. Remove the 2 nuts and brush holder.

  1. Remove the plate seal.



5. REMOVE GENERATOR COIL ASSEMBLY


    A075671
  1. Remove the 4 bolts.



    A075672E03
  1. Using SST, remove the coil.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)



6. REMOVE GENERATOR ROTOR ASSEMBLY


    A075673
  1. Remove the washer and rotor.