GENERATOR > INSPECTION |
| 1. INSPECT GENERATOR ROTOR ASSEMBLY |
![]() |
Check the rotor for open circuit.
Using an ohmmeter, check that there is continuity between the slip rings.
![]() |
Check the rotor for ground.
Using an ohmmeter, check that there is no continuity between the slip ring and rotor.
If there is continuity, replace the rotor.
Check that the slip rings are not rough or scored.
If rough or scored, replace the rotor.
![]() |
Using vernier calipers, measure the slip ring diameter.
| 2. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Using vernier caliper, measure the exposed brush length.
| 3. INSPECT GENERATOR ROTOR BEARING |
Check the bearing is not rough or worn.
If necessary, replace the bearing.
| 4. INSPECT GENERATOR DRIVE END FRAME BEARING |
Check the bearing is not rough or worn.
If necessary, replace the bearing.
| 5. REMOVE GENERATOR ROTOR BEARING |
![]() |
Remove the 4 screws, bearing retainer and bearing.
![]() |
Using SST and a hammer, tap out the bearing.
| 6. INSTALL GENERATOR ROTOR BEARING |
![]() |
Using SST and a press, press in a new bearing.
Install the bearing retainer with the 4 screws.
| 7. REMOVE GENERATOR DRIVE END FRAME BEARING |
![]() |
Using SST, remove the bearing cover (outside) and bearing.
Remove the bearing cover (inside).
![]() |
Place the bearing cover (inside) on the rotor.
| 8. INSTALL GENERATOR DRIVE END FRAME BEARING |
![]() |
Using SST and a press, press in a new bearing.
![]() |
Using SST, push in the bearing cover (outside).