Home › ENGINE ยท 2UZ-FE › CHARGING › GENERATOR

GENERATOR > REMOVAL

for Preparation Click here



1. DISCONNECT BATTERY NEGATIVE TERMINAL


2. REMOVE RADIATOR UPPER SUPPORT SEAL
  1. Remove the 11 clips and radiator upper support seal.



3. REMOVE FAN AND GENERATOR V BELT


    B000809
  1. Loosen the belt tension by turning the belt tensioner counterclockwise, and then remove the fan and generator V belt.

    HINT:
    The pulley bolt for the belt tensioner has left-hand thread.



4. REMOVE FAN AND FLUID COUPLING
  1. Separate the 2 oil cooler hoses from fan shroud.

  1. Remove the 3 bolts and separate the fan shroud from radiator.

  1. Remove the 4 nuts and separate the fan w/ fluid coupling from engine.

  1. Remove the fan shroud and fan w/ fluid coupling from the vehicle at the same time.



5. REMOVE VANE PUMP ASSEMBLY
  1. Disconnect the vacuum hose.

  1. Remove the nut, 2 bolts and vane pump assembly.

    HINT:
    Hand up the hoses instead of detaching.



6. REMOVE GENERATOR ASSEMBLY


    A066671
  1. Disconnect the generator connector.

  1. Remove the terminal cap and nut, and disconnect the generator wire.

  1. Disconnect the alternator wire clamp from the cord clip on the generator.

  1. Remove the bolt, 2 nuts and generator.