Home › ENGINE ยท 2UZ-FE › STARTING › STARTER

STARTER > DISASSEMBLY

for Preparation Click here



1. REMOVE STARTER YOKE ASSEMBLY


    A074961
  1. Remove the nut and disconnect the terminal C wire.

  1. Remove the 2 through bolts.

  1. Pull out the starter yoke assembly with the armature assembly.

  1. Remove the O-ring from the starter yoke assembly.



2. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    B004654
  1. Remove the 2 screws with O-ring and end cover from the field frame.

  1. Remove the O-ring from the field frame.



    P010568
  1. Using a screwdriver, hold the spring back and disconnect the brush from the brush holder.

  1. Disconnect the 4 brushes, and remove the brush holder.



3. REMOVE STARTER ARMATURE ASSEMBLY
  1. Remove the starter armature assembly from starter yoke assembly.



4. REMOVE STARTER CLUTCH SUB-ASSEMBLY


    A074962
  1. Remove the 2 screws and starter drive housing.



    B004552E01
  1. Remove the return spring, idler gear, bearing and starter clutch sub-assembly from the starter housing.



    ST00948E02
  1. Using a magnetic finger, remove the steel ball from the clutch shaft hole.