Home › ENGINE ยท 2UZ-FE › STARTING › STARTER

STARTER > REASSEMBLY

for Preparation Click here



1. INSTALL STARTER CLUTCH SUB-ASSEMBLY


    A072547E01
  1. Apply grease to the steel ball, return spring, clutch rollers and starter idler pinions.

  1. Install the steel ball.

  1. Install a new O-ring to the starter housing.

  1. Insert the return spring into the magnet starter switch hole.

  1. Install the starter clutch sub-assembly, idler gear and bearing.



    A074962
  1. Install the starter housing to the magnet switch assembly with the 2 screws.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }



2. INSTALL STARTER BRUSH HOLDER ASSEMBLY


    P010568
  1. Align the claw of the brush holder with the claw groove of the starter yoke assembly.

  1. Place the brush holder on the starter yoke assembly.

  1. Using a screwdriver, hold the brush spring back.

  1. Connect the brush into the brush holder.

  1. Connect the 4 brushes.

    NOTICE:
    Check that the positive (+) lead wires are not grounded.

  1. Install an O-ring to the groove of the starter yoke.



    B004654
  1. Install 2 new O-rings and the end cover with the 2 screws.

    Torque:
    3.8 N*m{ 39 kgf*cm , 34 in.*lbf }



3. INSTALL STARTER YOKE ASSEMBLY


    B012328
  1. Install a new O-ring to the groove of the starter yoke assembly.

  1. Align the protrusion of the starter yoke assembly with the groove of the magnetic switch.



    A074961
  1. Install the starter yoke assembly with the 2 through bolts.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }

  1. Connect the terminal C wire with the nut.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }