Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG CUTOFF SWITCH

CURTAIN SHIELD AIRBAG CUTOFF SWITCH > INSPECTION

for Preparation Click here



1. INSPECT RSCA OFF INDICATOR


    H043802
  1. Turn the ignition switch to the ON position.

  1. Check that the RSCA OFF indicator comes on for approximately 3 seconds and then goes off.

  1. Check that the RSCA OFF indicator goes off after pressing the curtain airbag cut off switch for approximately 2 seconds.



2. INSPECT CURTAIN SHIELD AIRBAG CUTOFF SWITCH
  1. Remove the instrument panel finish panel sub-assembly lower .

  1. Remove the curtain airbag cutoff switch from the instrument panel finish panel sub-assembly lower.



    H043798E01
  1. Measure the resistance according to the value(s) in the table below.
    Tester connection
    Condition
    Specified condition
    SW (3) - E (4)
    OFF (Release)
    10 kΩ or higher
    SW (3) - E (4)
    ON (Pushed in)
    Below 1 Ω

  1. Inspect the illumination operation.

    1. Connect the battery positive terminal to terminal ILL+ (2) of the connector, and the battery negative terminal to terminal ILL- (1), and check that the indicator comes on.