STEERING PAD SWITCH > INSTALLATION |
| 1. INSTALL STEERING PAD SWITCH |
| 2. INSTALL STEERING PAD ASSEMBLY |
![]() |
Support the steering pad with one hand as shown in the illustration.
Connect the 2 connectors to the steering pad.
Connect the horn connector.
Confirm that the circumference groove of the "torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.
Using a "torx" socket wrench (T30), tighten the 2 "torx" screws.
| 3. INSTALL STEERING WHEEL COVER LOWER NO. 3 |
Install the steering wheel No.3 cover lower.
| 4. INSTALL STEERING WHEEL COVER LOWER NO. 2 |
Install the steering wheel No.2 cover lower.
| 5. CONNECT BATTERY NEGATIVE TERMINAL |
| 6. INSPECT STEERING PAD ASSEMBLY |
![]() |
With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Make sure that the horn sounds.
| 7. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).