Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH

STEERING PAD SWITCH > REMOVAL

for Preparation Click here



1. SEPARATE BATTERY NEGATIVE TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



2. REMOVE STEERING WHEEL COVER LOWER NO. 2
  1. Using a screwdriver, remove the steering wheel No. 2 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



3. REMOVE STEERING WHEEL COVER LOWER NO. 3
  1. Using a screwdriver, remove the steering wheel No. 3 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



4. REMOVE STEERING PAD ASSEMBLY


    F043322
  1. Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.



    H042354
  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Using a screw driver, disconnect the 2 connectors from the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the steering pad.



5. REMOVE STEERING PAD SWITCH


    E062430
  1. Disconnect the connector.

  1. Disconnect the connector of cruise control main switch.

  1. Remove the screw.



    I033301E02
  1. Disengage the meshing of 2 pins remove the steering pad switch LH.