DTC P2772 Transfer "L4" Switch Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2772 | Transfer L4 position switch remains ON while vehicle is running under following conditions for 1.8 seconds or more (1-trip detection logic) (a) Output shaft speed between 1,000 and 3,000 rpm (b) Transfer shift position is H |
|
| Related DTCs | P2772: Transfer L4 position switch/ON malfunction |
| Required sensors/Components | Transfer L4 position switch |
| Frequency of operation | Continuous |
| Duration | ON malfunction (A): 1.8 sec. ON malfunction (B): 0.5 sec. |
| MIL operation | 1 driving cycle |
| Sequence of operation | None |
| Output speed sensor circuit | Not circuit malfunction |
| Vehicle speed sensor circuit | Not circuit malfunction |
| Transfer neutral position switch | OFF |
| Output speed (Transfer output speed) | 1,000 to 3,000 rpm |
| Output speed (Transfer output speed) | 143 rpm or more |
| L4 switch | ON |
| Actual transfer gear ratio Transfer input speed/Transfer output speed | 0.9 to 1.1 |

| 1.INSPECT TERMINAL VOLTAGE (4WD ECU - ECM) |
![]() |
Disconnect the four wheel drive control ECU connector.
Turn the ignition switch ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| F9-24 (L4) - Body ground | 10 to 14 V |
|
| ||||
| NG | |
| 2.INSPECT TERMINAL VOLTAGE (ECM - 4WD ECU) |
![]() |
Turn the ignition switch ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| E6-13 (L4) - Body ground | 10 to 14 V |
|
| ||||
| NG | ||
| ||