Home › TRANSMISSION ยท A750F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM (for 2UZ-FE)

DTC    P2772    Transfer "L4" Switch Circuit

for Preparation Click here


DESCRIPTION

The ECM detects the signal from the transfer L4 position switch.
This DTC indicates that the transfer L4 position switch remains on.

DTC No.
DTC Detection Condition
Trouble Area
P2772
Transfer L4 position switch remains ON while vehicle is running under following conditions for 1.8 seconds or more (1-trip detection logic)
(a) Output shaft speed between 1,000 and 3,000 rpm
(b) Transfer shift position is H
  1. Short in transfer L4 position switch circuit
  2. Four wheel drive control ECU
  3. ECM

MONITOR DESCRIPTION

The ECM monitors the transfer-case L4 position switch to determine when the transfer-case L4 gear is engaged. If the transfer-case L4 gears remain engaged under the following conditions, the ECM will conclude that there is a malfunction of the L4 position switch:
  1. L4 switch indicated that the L4 transfer-case gears are engaged.
  2. Transfer-case shifter is in the "H" position.
  3. Transfer-case output shaft rpm is between 1,000 and 3,000 rpm.
  4. The specified time period has elapsed.
If all of the above conditions are detected, the ECM will conclude that there is a malfunction of the L4 switch, and illuminate the MIL and store the DTC.

MONITOR STRATEGY


Related DTCs
P2772: Transfer L4 position switch/ON malfunction
Required sensors/Components
Transfer L4 position switch
Frequency of operation
Continuous
Duration
ON malfunction (A): 1.8 sec.
ON malfunction (B): 0.5 sec.
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


All: 
Output speed sensor circuit
Not circuit malfunction
Vehicle speed sensor circuit
Not circuit malfunction
Transfer neutral position switch
OFF

ON malfunction (A) 
Output speed (Transfer output speed)
1,000 to 3,000 rpm

ON malfunction (B) 
Output speed (Transfer output speed)
143 rpm or more

TYPICAL MALFUNCTION THRESHOLDS

Both of the following conditions are met: ON malfunction (A) and (B)

  1. ON malfunction (A) 
    L4 switch
    ON

    ON malfunction (B) 
    Actual transfer gear ratio
    Transfer input speed/Transfer output speed
    0.9 to 1.1

WIRING DIAGRAM


G039615E01


INSPECTION PROCEDURE

1.INSPECT TERMINAL VOLTAGE (4WD ECU - ECM)


    C095382E01
  1. Disconnect the four wheel drive control ECU connector.

  1. Turn the ignition switch ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    F9-24 (L4) - Body ground
    10 to 14 V



OK
CHECK AND REPLACE FOUR WHEEL DRIVE CONTROL ECU
NG


2.INSPECT TERMINAL VOLTAGE (ECM - 4WD ECU)


    A131509E66
  1. Turn the ignition switch ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    E6-13 (L4) - Body ground
    10 to 14 V



OK
REPAIR OR REPLACE HARNESS OR CONNECTOR
NG

REPLACE ECM