Home › SUSPENSION & AXLE › SUSPENSION › FRONT UPPER SUSPENSION ARM

FRONT UPPER SUSPENSION ARM > REMOVAL

for Preparation Click here



1. REMOVE FRONT DISC WHEEL


2. INSPECT FRONT SUSPENSION UPPER ARM ASSEMBLY LH
  1. Check that there is no looseness on the ball joint by shaking the upper arm up and down by hand.



3. REMOVE SKID CONTROL SENSOR WIRE


    C099168
  1. Remove the 2 bolts, and disconnect the skid control sensor wire.



4. REMOVE FRONT SUSPENSION UPPER ARM ASSEMBLY LH


    G020151E02
  1. Support the front suspension lower arm LH with a jack.

  1. Remove the clip and the nut.

  1. Using SST, disconnect the upper ball joint from the steering knuckle.

    SST
    09628-62011  



    G020152
  1. Remove the bolt and the bracket.



    G020153
  1. Remove the bolt, the 2 washers and the nut.

  1. Remove the front suspension upper arm assembly.



5. REMOVE FRONT SUSPENSION UPPER ARM BUSH LH


    G020154
  1. Using a hammer and chisel, raise the flange of the bushing diagonally as shown in the illustration.



    G020155E02
  1. Using SST and a press remove the front suspension upper arm bush LH (front side).

    SST
    09613-26010  
    09710-22021   (09710-01031)
    09950-00020  

  1. Replace the rear side by the same procedures with the front side.