Home › SUSPENSION & AXLE › SUSPENSION › FRONT UPPER SUSPENSION ARM

FRONT UPPER SUSPENSION ARM > INSPECTION

for Preparation Click here



1. INSPECT FRONT SUSPENSION UPPER ARM ASSEMBLY LH


    G020170
  1. As shown in the illustration, flip the ball joint stud back and forth 5 times, before installing the nut.

  1. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per 1 turn and take the torque reading on the 5th turn.

    Torque:
    Turning torque:
    4.5 N*m{ 46 kgf*cm , 40 in.*lbf } or less

  1. Check for any cracks and grease leaks on the ball joint dust cover.