Home › SUSPENSION & AXLE › SUSPENSION › FRONT SUSPENSION LOWER NO. 1 ARM

FRONT SUSPENSION LOWER NO. 1 ARM > INSPECTION

for Preparation Click here



1. REMOVE FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO. 1 LH


    G021680
  1. As shown in the illustration, flip the ball joint stud back and forth 5 times, before installing the nut.

  1. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per 1 turn and take the torque reading on the 5th turn.

    Torque:
    Turning torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf } or less

  1. Check for any cracks and grease leaks on the ball joint dust cover.