Home › SUSPENSION & AXLE › SUSPENSION › REAR SHOCK ABSORBER (w/ REAS)

REAR SHOCK ABSORBER (w/ REAS) > INSTALLATION

for Preparation Click here



1. INSTALL SHOCK ABSORBER ASSEMBLY REAR LH
  1. Install the lower bracket to the shock absorber assembly rear LH.



    D028457
  1. Install the cushion retainer, cushion No. 1 and shock absorber assembly rear LH with the nut.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }



    D028459
  1. Refer to NOTICE below.

    NOTICE:
    1. Be sure to fit the positioning protrusion of the bracket to a hole on the frame.
    2. to a hole on the frame. Install the hose as it comes in the front.



    D028132
  1. Install the shock absorber assembly rear LH with the bolt.



    D028262
  1. Install the bracket with the bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }

  1. Using a wrench to hold the bracket, install the joint.

    HINT:
    Tighten the joint so that the gap spacing becomes 1 mm (0.04 in.).

    Torque:
    Reference:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }



2. INSTALL REAR STABILIZER LINK ASSEMBLY


    D028258
  1. Install the stabilizer link with the nut (LH side).

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.

  1. Install the 2 retainers and the cushion to the stabilizer link.



    D028259
  1. Hold the stabilizer bar link with a wrench, and install the nut, retainer, cushion and link.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }



3. INSTALL REAR WHEEL

Torque:
112 N*m{ 1,137 kgf*cm , 83 ft.*lbf }



4. STABILIZE SUSPENSION
  1. Jack down the vehicle.

  1. Bounce the vehicle up and down several times to stabilize the suspension.



5. FULLY TIGHTEN SHOCK ABSORBER ASSEMBLY REAR LH


    D028132
  1. Fully tighten the bolt.

    Torque:
    98 N*m{ 1,000 kgf*cm , 72 ft.*lbf }



6. INSPECT FLUID LEAK

HINT:
(Click here)