REAR PNEUMATIC CYLINDER > INSTALLATION |
| 1. INSTALL PNEUMATIC CYLINDER ASSEMBLY REAR LH |
![]() |
Install the pneumatic cylinder assembly with the clip.
Connect the height control tube (Click here).
![]() |
When using safety stands and jack:
Jack up the rear axle assembly until the bottom of the pneumatic cylinder assembly touches the rear axle assembly and install the clip at the lower side of the pneumatic cylinder assembly into the keyhole in the rear axle assembly.
Remove the safety stands with care not to extend the pneumatic cylinder assembly when jacking down the vehicle till it sits on the ground.
When using a swing arm type lift:
Lower the vehicle till the tires hit the ground, and continue lowering slowly until the bottom of the pneumatic cylinder assembly touches the rear axle assembly.
Align the seating pin on the cylinder with the keyhole in the rear axle assembly and install the pneumatic cylinder assembly on the rear axle assembly.
Lower the lift carefully so as not to extend the pneumatic cylinder assembly.
Start the engine and replenish the pneumatic cylinder assembly with air.
| 2. INSPECT AIR LEAK |
| 3. INSPECT VEHICLE HEIGHT |