Home › SUSPENSION & AXLE › SUSPENSION › REAR LOWER CONTROL ARM

REAR LOWER CONTROL ARM > INSTALLATION

for Preparation Click here



1. INSTALL LOWER CONTROL ARM ASSEMBLY LH
  1. Install the lower control arm assembly, temporarily tighten the nut, washer and bolt.



    D028142
  1. Install the rear axle housing, temporarily tighten the bolt, washer and nut.



2. CONNECT PARKING BRAKE CABLE ASSEMBLY NO. 3
  1. Connect the parking brake cable assembly No.3 with the bolt.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }



3. INSTALL REAR WHEEL

Torque:
112 N*m{ 1,137 kgf*cm , 83 ft.*lbf }



4. STABILIZE SUSPENSION
  1. Jack down the vehicle.

  1. Bounce the vehicle up and down several times to stabilize the suspension.



5. FULLY TIGHTEN LOWER CONTROL ARM ASSEMBLY LH


    D028252
  1. Fully tighten the 2 bolts.

    Torque:
    130 N*m{ 1,326 kgf*cm , 96 ft.*lbf }

    HINT:
    While fixing the nut, turn and remove the bolt.