Home › SUSPENSION & AXLE › SUSPENSION › CENTER CONTROL ABSORBER TUBE (w/ REAS)

CENTER CONTROL ABSORBER TUBE (w/ REAS) > INSTALLATION

for Preparation Click here



1. INSTALL CENTER CONTROL ABSORBER TUBE LH


    D028474
  1. Install the center control absorber tube (Rear side) with the bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



    D028266
  1. Using a spanner to hold the counter control absorber assembly, install the joint.



    D028267E01
  1. Refer to HINT below.

    HINT:
    Tighten the joint so that the gap spacing becomes 1 mm (0.04 in.)

    Torque:
    Reference:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }



    D028476
  1. Pass through the center control absorber tube (Front side) between the body and the frame.



    D028475
  1. Pass the opposite side of the center control absorber tube over the frame.

    NOTICE:
    Do not bend the center control tube excessively.



    D028473
  1. Using a spanner to hold the bracket, install the joint.



    D028267E01
  1. Refer to HINT below.

    HINT:
    Tighten the joint so that the gap spacing becomes 1 mm (0.04 in.)

    Torque:
    Reference:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }



    D028268
  1. Using a spanner to hold the bracket, install the joint.



    D028267E01
  1. Refer to HINT below.

    HINT:
    Tighten the joint so that the gap spacing becomes 1 mm (0.04 in.)

    Torque:
    Reference:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }



2. INSTALL TUBE PROTECTOR LH


    D028462
  1. Install the tube protector LH with the bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



3. INSPECT FLUID LEAK

HINT:
(Click here)