Home › SUSPENSION & AXLE › SUSPENSION › CENTER CONTROL ABSORBER TUBE (w/ REAS)

CENTER CONTROL ABSORBER TUBE (w/ REAS) > REMOVAL

for Preparation Click here


NOTICE:
Be sure to read PRECAUTIONS before performing this procedure (Click here).



1. REMOVE TUBE PROTECTOR LH


    D028462
  1. Remove the bolt and the tube protector LH.



2. REMOVE CENTER CONTROL ABSORBER TUBE LH


    D028266
  1. Using a spanner to hold the center control absorber assembly LH, disconnect the joint.

    NOTICE:
    Check that all four shock absorbers are fully extended to the normal suspension rebound point.



    D028268
  1. Using a spanner to hold the bracket, remove the joint.



    D028470
  1. Using a pliers, cut the center control absorber tube. Use a container to catch absorber as it drains out.

  1. Remove the center control absorber tubes from the frame.