Home › ENGINE ยท 1GR-FE › STARTING › STARTER (for Standard)

STARTER (for Standard) > INSTALLATION

for Preparation Click here



1. INSTALL STARTER ASSEMBLY (for 2WD)
  1. Install the starter assembly with the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Connect the wire harness to the terminal 30 and install the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 7 ft.*lbf }

  1. Connect the terminal 50 to the starter assembly.



2. CONNECT WIRE HARNESS (for 2WD)
  1. Connect the wire harness to the cylinder block and install the bolt.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



3. INSTALL NO. 2 MANIFOLD STAY (for 2WD)
  1. Install the No. 2 manifold stay with the 3 bolts.

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }



4. INSTALL ENGINE REAR UNDER COVER ASSEMBLY (for 2WD)
  1. Install the engine rear under cover assembly with the 4 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



5. CONNECT BATTERY NEGATIVE TERMINAL (for 2WD)
  1. Connect the battery negative terminal.



6. INSTALL STARTER ASSEMBLY (for 4WD)
  1. Install the starter assembly with the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Connect the wire harness to the terminal 30 and install the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 7 ft.*lbf }

  1. Connect the terminal 50 to the starter assembly.



7. INSTALL NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY (for 4WD)


    A076412
  1. Install the steering sliding yoke to No. 2 steering intermediate shaft.

  1. Install the bolt B and tighten the bolt B and A.

    Torque:
    36 N*m{ 370 kgf*cm , 27 ft.*lbf }



8. INSTALL FRONT FENDER REAR SPLASH SHIELD LH (for 4WD)
  1. Install the front fender rear splash shield LH with the 5 clips.



9. INSTALL NO. 2 FRONT EXHAUST PIPE ASSEMBLY (for 4WD)
  1. Install 2 new gaskets and No. 2 exhaust manifold with the 2 bolts and 2 nuts.

    Torque:
    Nut:
    62 N*m{ 630 kgf*cm , 46 ft.*lbf }
    Bolt:
    48 N*m{ 490 kgf*cm , 35 ft.*lbf }

  1. Connect the heated oxygen sensor (bank 2) connector.



10. INSTALL ENGINE REAR UNDER COVER ASSEMBLY (for 4WD)
  1. Install the engine rear under cover assembly with the 4 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



11. CONNECT BATTERY NEGATIVE TERMINAL (for 4WD)
  1. Connect the battery negative terminal.