Home › ENGINE ยท 1GR-FE › STARTING › STARTER (for Standard)

STARTER (for Standard) > DISASSEMBLY

for Preparation Click here



1. REMOVE REPAIR SERVICE STARTER KIT


    A076123
  1. Remove the nut, and disconnect the lead wire from the repair service starter kit.



    A076124
  1. Remove the 2 screws which are used to secure the repair service starter drive housing.

  1. Remove the repair service starter kit.

  1. Remove the return spring and plunger.



2. REMOVE STARTER YOKE ASSEMBLY


    A076127
  1. Remove the 2 through bolts, and pull out the starter yoke assembly together with the commutator end frame assembly.



3. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY
  1. Remove the commutator end frame assembly from the starter yoke assembly.



4. REMOVE STARTER ARMATURE PLATE
  1. Remove the starter armature plate from the starter yoke assembly.



5. REMOVE STARTER COMMUTATOR END FRAME COVER
  1. Using a screwdriver, remove the cover.



6. REMOVE STARTER ARMATURE ASSEMBLY


    A073993
  1. Using snap ring pliers, remove the snap ring and plate washer.

  1. Remove the starter armature assembly from commutator end frame assembly.



7. REMOVE PLANETARY GEAR


    A076128
  1. Remove the 3 planetary gears.



8. REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY


    A073990
  1. Remove the starter center bearing clutch and drive lever set pin together from the starter drive housing.

  1. Remove the drive lever set pin from the starter center bearing clutch.