FUEL SYSTEM > GENERAL



OUTLINE
  1. A compact 12-hole type fuel injector assembly is used to increase atomization of the fuel.

  2. A quick connector is used to connect the fuel pipe with the fuel hose for excellent serviceability.



  3. A fuel delivery pipe sub-assembly made of plastic is used.


    W102184E03


    Text in Illustration 
    *1
    Fuel Pump Module Assembly
    *2
    Fuel Filter Assembly
    *3
    Fuel Pump
    *4
    Fuel Pressure Pulsation Damper Assembly
    *5
    Fuel Delivery Pipe Sub-assembly
    *6
    Fuel Injector Assembly
    *7
    Fuel Pressure Regulator Assembly
    *8
    Fuel Tank Assembly
    *9
    Charcoal Canister Assembly
    -
    -

  4. A compact fuel pump in which a fuel filter is integrated in the fuel pump module assembly is used.

  5. A fuel cut control is used to stop the fuel pump if the SRS airbag is deployed in a frontal, side or rear side collision.

  6. Fuel pressure is set to 324 kPa (3.3 kgf/cm2, 46.9 psi) to improve startability with E20 fuel.

    HINT:
    E20 fuel is gasoline blended with 20% ethanol.