CAN COMMUNICATION SYSTEM > GENERAL



OUTLINE
  1. The Controller Area Network (CAN) uses 2 different CAN buses: CAN V bus and power management bus for high-speed communication (500 kbps) and CAN MS bus for medium-speed communication (250 kbps).

  2. The CAN has 2 terminating resistors which are necessary for accurate judgment of communication on the main bus.

  3. The terminating resistors for each bus are located as shown in the following table.

    Bus
    Terminating Resistor Location
    CAN V Bus
    1. ECM
    2. Combination Meter Assembly
    Power Management Bus
    1. Power Management Control ECU
    2. ECM
    CAN MS Bus
    1. Main Body ECU (Multiplex Network Body ECU)
    2. Drive Monitor Switch*1
    3. Combination Meter Assembly*2

    1. *1: Models with multi-terrain select system
    2. *2: Models with seat position memory

  4. The main body ECU (multiplex network body ECU) has a gateway function and is used to transmit data between the CAN MS bus and the CAN V bus.

  5. The power management control ECU has a gateway function and is used to transmit data between the power management bus and the CAN V bus.