OCCUPANT CLASSIFICATION SYSTEM > DETAILS



FUNCTION OF MAIN COMPONENTS
  1. The main components have the following functions:

    Component
    Function
    Occupant Classification ECU
    The occupant classification ECU judges whether the front passenger seat is occupied using signals from 4 front occupant classification sensors and front passenger seat belt buckle switch.
    Front Occupant Classification Sensor LH/RH
    The resistance values of these sensors, which vary in accordance with the distortion that acts on the brackets, are output to the occupant classification ECU.
    Rear Occupant Classification Sensor LH/RH
    Front Seat Inner Belt Assembly
    Front Passenger Seat Belt Buckle Switch
    The front passenger seat belt buckle switch detects if the front passenger seat belt is fastened.
    Combination Meter Assembly
    SRS Warning Light
    The SRS warning light turns on up to alert the driver when the center airbag sensor assembly detects a malfunction in the airbag system.
    Telltale Lamp Assembly
    AIRBAG ON/OFF Indicator Lights
    1. The AIRBAG ON/OFF indicator lights inform the driver whether the occupant classification ECU puts the front passenger airbag assembly, passenger side knee airbag assembly and front passenger outer belt assembly RH into an active state or inactive state.
    2. If a malfunction occurs in the occupant classification system, the AIRBAG OFF indicator light and the SRS warning light come on.


OPERATING CONDITION
  1. The front passenger SRS items and indicator lights operate as follows according to the occupant classification:

    Items
    Occupant Classification
    Adult
    Child
    Child Seat
    Unoccupied
    Malfunction
    Front Passenger SRS Components
    Front Airbag
    X
    -
    -
    -
    -
    Knee Airbag
    X
    -
    -
    -
    -
    Side Airbag
    X
    X
    X
    X
    X
    Curtain Shield Airbag
    X
    X
    X
    X
    X
    Seat Belt Pretensioner
    X
    X
    X
    -
    X
    AIRBAG ON/OFF Indicator Lights
    ON Indicator Light
    ON
    OFF
    OFF
    OFF
    OFF
    OFF Indicator Light
    OFF
    ON
    ON
    OFF
    ON

    1. X: Deploys
    2. -: Does not deploy


SYSTEM CONTROL
  1. In the occupant classification system, the occupant classification ECU calculates the weight of the occupant based on signals from the occupant classification sensors.

  2. This system recognizes the occupant as a child if it detects a weight of less than 32 kg (70.5 lb), and disables the front passenger airbag assembly and front seat outer belt assembly RH.

  3. The occupant classification ECU contains criteria value "A" to judge whether the seat is being occupied by a child or a child seat in accordance with the signals from the 4 occupant classification sensors and front seat inner belt assembly, and criteria value "B" to judge whether the occupant is an adult or child (with child seat).

  4. The occupant classification ECU makes an unoccupied judgment when the judgment value is lower than criteria value "A" and the front passenger seat belt buckle switch is off.



  5. If the ignition switch is turned to ON in this state, the system performs an initial check, and does not illuminate the AIRBAG ON/OFF indicator lights. Then, the system prohibits the deployment of the front passenger airbag assembly and the front seat outer belt assembly RH, and does not blink the seat belt warning light.


    Y101097E07

  6. If the judgment value is lower than criteria value "B" and the front seat inner belt assembly (front passenger side seat belt buckle switch) is ON, the occupant classification ECU judges that a child seat is installed.

  7. If the judgment value is higher than criteria value "A", but lower than criteria value "B", and the front seat inner belt assembly (front passenger side seat belt buckle switch) is OFF, the occupant classification ECU judges that the seat is being occupied by a child.



  8. When the engine switch is turned on (IG) under these conditions, the system performs an initial check and illuminates the AIRBAG OFF indicator light to indicate that the front passenger airbag assembly and passenger side knee airbag assembly have been deactivated.


    Y101111E02

  9. After the occupant classification ECU judges that a child seat is installed, the AIRBAG OFF indicator light does not go off unless the front seat inner belt assembly (front passenger side seat belt buckle switch) is turned OFF.

  10. When the judgment value is higher than criteria value "B", the occupant classification ECU judges that the seat is occupied by an adult.



  11. If the engine switch is turned on (IG) in this state, the system performs an initial check and illuminates the AIRBAG ON indicator light, indicating that the front passenger airbag assembly, passenger side knee airbag assembly, front seat side airbag assembly RH and front passenger outer belt assembly RH are active.


    Y101098E02

  12. After the occupant classification ECU judges that the occupant is an adult, and if the judgment value is determined as criteria value "B" or less according to occupant load movement, the ECU continues adult judgment for approximately 10 seconds before switching the child judgment.



  13. After the ignition switch is turned to ON, the occupant classification ECU lights up the AIRBAG ON/OFF indicator lights via center airbag sensor assembly based on the timing chart below in order to check the indicator light circuits.


    Y100049E01


DIAGNOSIS
  1. If the occupant classification ECU detects a malfunction in the occupant classification system, the occupant classification ECU stores the malfunction data in memory. If the center airbag sensor assembly detects a malfunction in the occupant classification ECU, the center airbag sensor assembly illuminates the SRS warning light and AIRBAG OFF indicator light.

  2. The occupant classification ECU outputs 5-digit Diagnostic Trouble Codes (DTCs) to the Techstream.

  3. The 5-digit DTCs can be read after connecting the Techstream to the DLC3. For details, refer to the Repair Manual.