CRUISE CONTROL SYSTEM > DETAILS |
| FUNCTION |
The cruise control has the following control functions.
| Function | Outline |
| Constant Speed Control | The ECM compares the actual vehicle speed and the set speed and if the vehicle speed is lower than the set speed, it uses the throttle control motor to increase the throttle opening. |
| Set Control | When the vehicle has met the following condition, and the cruise control main switch is pressed to the -/SET side and released after the ON-OFF button on the cruise control main switch is pressed to turn the system on, the ECM will store the vehicle speed and then maintain the vehicle constantly at that speed and the stored vehicle speed and SET are indicated on the combination meter.
|
| Low Speed Limit Control | The low speed limit is the lowest speed that cruise control can be set at and it is designed to be approximately 40 km/h (25 mph). The cruise control cannot be set below that speed. If the vehicle speed drops below that speed while running in the cruise control, the cruise control will be canceled automatically. However the set speed is kept in memory. |
| COAST Switch Control | When the cruise control main switch is held to the -/SET side, the vehicle speed and the set vehicle speed change as follows:
|
| Tap Down Control | When the cruise control main switch is pushed momentarily (approximately 0.6 sec.) to the -/SET side, the vehicle speed and the vehicle set speed change as follows:
|
| ACC Switch Control | When the cruise control main switch is held to the +/RES side, the vehicle speed and the set vehicle speed change as follows:
|
| Tap Up Control | When the cruise control main switch is pushed momentarily (approximately 0.6 sec.) to the +/RES side, the vehicle speed and the set vehicle speed change as follows.
|
| RES Switch Control | If cruise control is canceled for any reason other than a malfunction or cruise control main switch operation and vehicle speed is more than the low speed limit, the vehicle speed is returned to the speed before the cancellation of cruise operation by pushing the cruise control main switch to the +/RES side. The cruise control mode can be resumed even if the vehicle speed drops below the low speed limit, because the speed in the memory is not cleared. |
| Automatic Transmission Control | When the vehicle is cruising uphill, the overdrive may turn off depending on ECT (Electronic Control Transmission) control. After the ECM judges that cruising uphill has ended (based on the throttle valve angle), the overdrive function will turn on again. There may be cases where the overdrive turns off when ACC or RES switch is used. |
| Manual Cancel Control | If one of the following signals is sent to the ECM, the cruise control is canceled accordingly.
|
| Automatic Cancel Control | If one of the following conditions occurs during cruise control operation, the speed that is set in the memory is cleared and the cruise control is canceled.
|
If the following condition occurs during cruise control operation, the speed that is set in the memory will be cleared and the cruise control will be canceled.
| |
If one of the following conditions occurs during cruise control operation, the speed that is set in the memory is cleared and the cruise control is canceled.
| |
If the following condition occurs during cruise control driving, the speed that is set in the memory will be cleared and the cruise control will be canceled.
| |
If one of the following conditions occurs during cruise control driving, the cruise control is canceled.
| |
| Diagnosis | If the ECM does not receive a vehicle speed signal for a predetermined period of time during cruising, or if cruise control is canceled (automatic cancel) due to a malfunction of the cruise control, stop light switch or vehicle speed signal, the ECM immediately blinks the cruise main indicator light due to the malfunction. The information relating to the malfunction will be stored in the ECM. |
| DIAGNOSIS |
If a malfunction occurs in the cruise control system during cruise control operation, the ECM automatically cancels the cruise control and blinks the cruise main indicator light to inform the driver of the malfunction. At this time, the ECM memorizes the malfunction in the form of 5-digit Diagnostic Trouble Codes (DTCs).
The 5-digit DTCs can be read by connecting Techstream to DLC3.
For details, refer to the Repair Manual.