EXHAUST SYSTEM > DETAILS



CONSTRUCTION


  1. Exhaust Manifold Sub-assemblies (RH and LH)

    1. Stainless steel exhaust manifolds with an integrated Three-Way Catalytic converter (TWC) are used for warm-up of the TWC and for weight reduction.



    2. The air injection pipe directs air from the air pump assembly to the air injection port on the cylinder head.


      W109862E01


      Text in Illustration 
      *1
      Exhaust Manifold Sub-assembly RH - TWC
      *2
      Exhaust Manifold Sub-assembly LH - TWC
      *3
      Air Injection Pipe
      -
      -



  2. Exhaust Pipe

    1. The exhaust pipes are made of stainless steel for improved rust resistance.

    2. A thin-wall, ceramic type TWC is used.

    3. A main muffler is used to ensure engine performance and reduce exhaust noise.



    4. A ball joint is used to join the front exhaust pipe assembly and the center exhaust pipe assembly. As a result, a simple and reliable construction for reducing vibration has been realized.


      W109863E01


      Text in Illustration 
      *1
      Front Exhaust Pipe Assembly
      *2
      Center Exhaust Pipe Assembly
      *3
      Main Muffler
      *4
      Tail Pipe Assembly
      *5
      Gasket
      *6
      Compression Spring
      *a
      Ball Joint
      -
      -