INTAKE SYSTEM > DETAILS |
| CONSTRUCTION |
Air Cleaner Assembly
A nonwoven, full-fabric type air cleaner filter element is used.
A carbon filter, which adsorbs the HC that accumulates in the intake system when the engine is stopped, is used in the air cleaner cap sub-assembly in order to reduce evaporative emissions. This filter is maintenance-free.

| *1 | Air Cleaner Cap Sub-assembly | *2 | Air Cleaner Filter Element Sub-assembly (Nonwovens Fabric) |
| *3 | Air Cleaner Case Sub-assembly | *4 | Carbon Filter |
Throttle Body
A cable-less type throttle body in which the throttle position sensor and the throttle control motor are integrated is used. It realizes excellent throttle valve control.
The throttle control motor uses a DC motor with excellent response and minimal power consumption. The ECM performs duty ratio control of the direction and the amperage of the current that flows to the throttle control motor in order to regulate the throttle valve angle.

| *1 | Throttle Position Sensor | *2 | Throttle Control Motor |
Intake Air Surge Tank
The intake air surge tank has been made of plastic to reduce the weight and the amount of heat transferred from the cylinder head. As a result, it has become possible to reduce the intake air temperature and improve the intake volumetric efficiency.

Intake Manifold
A light weight aluminum alloy is used for the intake manifold.
The No. 1 and No. 2 intake manifold to head gaskets have a rubber coating applied to their surfaces. They provide superior durability.

| *1 | Intake Manifold | *2 | No.1 Intake Manifold to Head Gasket |
| *3 | No.2 Intake Manifold to Head Gasket | - | - |
| *a | A - A Cross Section | - | - |
![]() | Rubber Coating | - | - |