SMART KEY SYSTEM > GENERAL



OUTLINE
  1. The smart key system has the following main functions, making it a very user-friendly system.

    Function
    Outline
    Start Function
    The start function is operated by simply pushing the engine switch while carrying the key. When the engine switch is pushed, the power management control ECU turns the ACC relay, IG1 relay and IG2 relay on or off to switch the power source pattern.*
    1. The power source pattern changes depending on depression of the brake pedal and the shift lever position.
    Start Function
    Engine Immobiliser
    The engine immobiliser function compares the ID code that is registered in the ID code box (immobiliser code ECU) with the ID code of the transponder chip that is embedded in the key.
    Steering Lock
    The steering lock function is operated to lock and unlock the steering wheel by using a lock/unlock motor in the steering column assembly.
    Cranking Hold
    When the engine switch is pushed once with the brake pedal depressed, the cranking hold function turns on the ST relay, and starts the engine.
    Entry Function
    Entry Unlock
    The doors unlock when a front outside door handle is gripped.
    1. The driver door outside door handle unlocks the driver door. (Driver Door Mode)
    2. The front passenger door outside door handle unlocks all doors and the back door. (Driver Door Mode)
    3. Either of the front door outside handle unlocks the all doors and the back door. (All Door Mode)
    Entry Lock
    All doors lock when the lock sensor on a front outside door handle is touched or if the back door lock switch is pushed.
    Entry Back Door Unlock
    All doors unlock when the back door unlock switch or back door opener switch is pushed.
    Wireless Door Lock Control
    The wireless door lock control function is a convenient system for locking and unlocking all the doors and back door at a distance. The basic operation is the same as that in the wireless door lock control system.
    *: In this chapter, the expression "power source" has been used in some locations to allow precise explanations. The power source condition is also expressed using conventional expressions such as "engine switch off", "engine switch on (ACC)" and "engine switch on (IG)".