TIRE PRESSURE WARNING SYSTEM > GENERAL |
| OUTLINE |
A direct-sensing type tire pressure warning system is used.
When the tire pressure warning system detects that the tire pressure becomes lower than the threshold, it will illuminate the tire pressure warning light to warn the driver.
The tire pressure warning antenna and receiver receives the tire pressure, temperature and ID code information from the 5 tire pressure warning valve and transmitters and transmits this information to the tire pressure warning ECU.
The tire pressure warning ECU monitors the tire pressure warning valve and transmitters to detect low tire pressure.
The operation of the tire pressure warning system includes warning function, initial check function and initialization function.
| PRECAUTION |
The system is disabled in the following conditions: (When the condition becomes normal, the system will work properly.)
Tires not equipped with a tire pressure warning valve and transmitter are used.
The ID codes are not registered in the tire pressure warning ECU.
The tire pressure is extremely high (500 kPa or more).
A tire pressure warning valve and transmitter battery is depleted.
The system will be disabled in the following conditions: (When the condition becomes normal, the system will work properly.)
Electric devices or facilities using similar radio frequencies are nearby.
If a wireless device or other equipment operating at a similar frequency is in use in the vehicle.
If a window tint that affects the radio wave signals is installed.
There is a lot of snow or ice on the vehicle, in particular around the wheels or wheel housings.
Non-genuine wheels are used.
Tire chains are used.
If the spare tire is in a location subject to poor radio wave signal reception.
If a large metallic object which can interfere with signal reception is put in the trunk.