SLIDING ROOF SYSTEM > DETAILS |
| SYSTEM CONTROL |
The sliding roof system has following functions:
| Function | Outline | Customizable* |
| Manual Open-and-close | This function opens or closes the sliding roof while the open switch or close switch is pressed for 0.3 seconds or less. The sliding roof stops as soon as the switch is released. | Standard (Not Customizable) |
| One-touch Auto Open | This function opens the sliding roof when the open switch is pressed for 0.3 seconds or more. | Standard (Not Customizable) |
| Manual Tilt Up-and-down | This function tilts up or down the sliding roof while the up switch or down switch is pressed for 0.3 seconds or less. The sliding roof stops as soon as the switch is released. | Standard (Not Customizable) |
| One-touch Auto Tilt Up | This function fully tilts up the sliding roof when the up switch is pressed for 0.3 seconds or more. | Standard (Not Customizable) |
| Jam Protection | The jam protection function automatically stops the sliding roof and moves it open half way (or to the fully tilted up position) if a foreign object gets jammed in the sliding roof during close or tilt down operation. | Standard (Not Customizable) |
| Key-off Operation | The key-off operation function makes it possible to operate the sliding roof for approximately 43 seconds after the ignition switch is turned to on (ACC) or off, if the front door is not opened. | Standard (Not Customizable) |
| Mechanical Key-linked Open-and-close |
| Default setting is off |
| Mechanical Key-linked Tilt up-and-down |
| Default setting is off |
| Transmitter-linked Open | When the main body ECU (multiplex network body ECU) receives an unlock signal from the transmitter continuously for 2.5 seconds or more via the door control receiver, the sliding roof drive gear sub-assembly (sliding roof ECU) opens the sliding roof. | Default setting is off |
| Transmitter-linked Tilt Up | When the main body ECU (multiplex network body ECU) receives an unlock signal from the transmitter continuously for 2.5 seconds or more via the door control receiver, the sliding roof drive gear sub-assembly (sliding roof ECU) tilt up the sliding roof. | Default setting is off |
| Sliding Roof Open Warning | When the ignition switch is turned from on (IG) to off and the driver door is opened with the sliding roof open, the buzzer in the combination meter assembly sounds once. | Standard (Not Customizable) |
Jam Protection Function
To control the jam protection function, the sliding roof ECU monitors the amount of movement and judges jamming of the sliding roof based on the pulse signals from Hall IC1, and the movement direction of the sliding roof from the phase difference between the pulses from Hall IC1 and Hall IC2.
