MONITOR SYSTEM > GENERAL



OUTLINE
  1. To assist the driver in parking the vehicle by monitoring the area behind it, the rear view monitor system has a rear television camera assembly mounted on the back door.

  2. A view of the area behind the vehicle is displayed on the multi-display (the screen of the radio and display receiver assembly*1 or navigation receiver assembly*2).

  3. When the shift lever is in R and the ignition switch is ON, the rear view monitor system displays an image of the area behind the vehicle on the radio and display receiver assembly*1 or navigation receiver assembly*2, via rear television camera assembly.

  4. The rear view display is canceled when the shift lever is moved to a position other than R.

    1. *1: Models with display audio system
    2. *2: Models with navigation system


PRECAUTION
  1. Ignition Switch Expressions

    1. The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

      Expression
      Ignition Switch
      (Position)
      Engine Switch
      (Condition)
      Ignition Switch off
      LOCK
      Off (Lock)
      Ignition Switch ACC
      ACC
      On (ACC)
      Ignition Switch ON
      ON
      On (IG)
      Engine Start
      START
      On (Start)

  2. General Precautions

    1. Do not rely entirely on the rear view monitor system. When backing up, drive the vehicle as carefully as you would drive one that is not equipped with the rear view monitor system.

    2. Never attempt to back up the vehicle only by observing the screen. If you do so, you could unexpectedly crash the vehicle or cause an accident because the image on the screen could differ from the actual situation. While backing up, also make sure to use the inside and outside rear view mirrors in order to directly verify the safety of the rear and surrounding areas.

  3. Rear Television Camera Precautions

    1. The area covered by the rear television camera assembly is limited. The rear television camera assembly does not show objects close to either corner of the bumper or show items under the bumper. The clearance distance that appears on the screen is different from the actual distance because the rear television camera assembly uses a wide-angle lens.

    2. The camera is unable to capture a clear image if the glass in front of the lens is dirty. Therefore, clean the glass if it has water drops, snow, or dirt on it.

    3. In the following cases, it may become difficult to see the images on the screen, but this is not a malfunction:

      1. In the dark (for example, at night).
      2. When the temperature near the lens is very high or low.
      3. When water droplets are adhering to the camera, or when humidity is high (for example, when it rains).
      4. When the camera has scratches or dirt on it.
      5. When foreign matter (for example, mud) is adhering to the camera lens.
      6. When the sun or the beam of headlights is shining directly into the camera lens.

    4. When the camera is used under fluorescent lights, sodium lights, or mercury lights etc., the lights and the illuminated area may appear to flicker.

    5. When washing the vehicle with a high-pressure washer, do not spray water on the rear television camera assembly or surrounding area. High-pressure water can damage the camera.