MONITOR SYSTEM > DETAILS



FUNCTION OF MAIN COMPONENTS

Component
Function
Rear Television Camera Assembly
Transmits a video signal of the area behind the vehicle to the radio and display receiver assembly*1 or navigation receiver assembly*2.
Radio and Display Receiver Assembly*1
  1. Receives signals from the park/neutral position switch assembly and turns the rear television camera assembly on and off.
  2. Displays the image transmitted by the rear television camera assembly on the screen.
Navigation Receiver Assembly*2
Park/Neutral Position Switch Assembly
Sends a shift R position signal to the radio and display receiver assembly*1 or navigation receiver assembly*2.
  1. *1: Models with Display Audio System
  2. *2: Models with Navigation System

OPERATING CONDITION
  1. This system operates when both the following conditions have been met:

    1. Ignition switch is ON.

    2. Shift lever is in R.


FUNCTION


  1. Area Displayed on Screen

    1. On the display, objects on the right of the vehicle appear on the right side of the display panel, and objects on the left of the vehicle appear on the left side of the display panel.



    2. The rear television camera uses a wide-angle lens. The perceived distance from images that appear on the screen differs from the actual distance.


      Y140591

      NOTICE:
      The area displayed on the screen may vary according to vehicle status or road conditions. The area covered by the rear television camera assembly is limited. The rear television camera assembly does not show objects close to either corner of the bumper or show the area under the bumper.


FAIL-SAFE
  1. The table below indicates fail-safe operation when a malfunction is detected:

    Malfunctioning Part
    Detection Item
    Function
    Rear Television Camera Assembly
    Rear television camera assembly malfunction signal is detected.
    System stops signal reception and displays a dark screen.