Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Disc cannot be Inserted or is Ejected Right After Insertion

for Preparation Click here


INSPECTION PROCEDURE

NOTICE:
After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.

1.CHECK IF A PROPER DISC IS INSERTED
  1. Make sure that the disc is an audio disc or a disc with MP3, WMA or AAC files, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.

    OK:
    Disc is normal

    HINT:
    1. Translucent or uniquely-shaped discs cannot be played.
    2. CDs with adhesive paper labels should not be played.
    3. Commercial audio CDs can be played.
    4. CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.
    5. MP3, WMA and AAC files on CD-ROMs, CD-Rs and CD-RWs can be played.
    6. For details on playable CDs, refer to the Owner's Manual.



NG
CHANGE DISC
OK


2.CHECK THAT DISC IS INSERTED PROPERLY
  1. Check whether or not the disc is inserted upside down.

    OK:
    Disc is properly inserted.



NG
INSERT DISC PROPERLY
OK


3.CLEAN DISC AND RECHECK


    I100151
  1. Clean the disc by wiping it clean with a soft cloth from the inside to the outside in a radial direction.

    OK:
    Malfunction disappears.

    NOTICE:
    Do not use a conventional record cleaner or anti-static preservative.



NG
Go to step 4
OK

END (DISC WAS DIRTY) 

4.REPLACE DISC AND RECHECK
  1. Replace the disc with a known good one and check that the malfunction disappears.

    OK:
    Malfunction disappears.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

END (DISC WAS FAULTY)