Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > CUSTOMIZE PARAMETERS

for Preparation Click here



CUSTOMIZING FUNCTION WITH TECHSTREAM (REFERENCE)

HINT:
The following items can be customized.

NOTICE:
  1. When the customer requests a change in a function, first make sure that the function can be customized.
  2. Record the current settings before customizing.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Customize.

  5. Select the setting by referring to the table below.

    Wiper 
    Display
    Default
    Content
    Setting
    Linked Rear Wiper Washer
    AVAIL
    Function to make the rear wiper run automatically after the washer function is used.
    NOT AVAIL or AVAIL
    Rewipe Function
    AVAIL
    Function to make the rear wiper run once automatically for a certain amount of time after the washer function is completed to prevent the dripping of washing fluid.
    NOT AVAIL or AVAIL
    Rear Wiper Interval Speed
    3 sec.
    Function used to change the time from when the rear wiper stops moving until it starts moving again in intermittent mode.
    3 sec., 2 sec., 4 sec. or 5 sec.
    Rear Wiper Retract Time
    3 sec.
    Function used to change the time from when the rear wiper stops moving after the rear wiper switch is turned off until the rear wiper is stored in the spoiler.
    3 sec., 4 sec., 5 sec. or 6 sec.