Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › THROTTLE BODY

THROTTLE BODY > REMOVAL

for Preparation Click here



1. REMOVE UPPER RADIATOR SUPPORT SEAL
  1. Remove the 13 clips and upper radiator support seal.



2. REMOVE COOL AIR INTAKE DUCT (for 4WD with Intuitive Parking Assist System)


    B353485
  1. Remove the 4 clips and cool air intake duct.



3. REMOVE FRONT LOWER BUMPER COVER (w/o Intuitive Parking Assist System)
  1. Remove the clip, 5 bolts and front lower bumper cover.



4. REMOVE FRONT LOWER BUMPER COVER (w/ Intuitive Parking Assist System)
  1. Remove the clip, 4 bolts and front lower bumper cover.



5. REMOVE AIR INTAKE DUCT LH (w/ Intuitive Parking Assist System)


    B353484
  1. Remove the clip and bolt.

  1. Remove the 2 screws and air intake duct LH.



6. REMOVE AIR INTAKE DUCT RH (w/ Intuitive Parking Assist System)

HINT:
Use the same procedure as for the LH side.



7. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts.



    A224743
  1. Unhook the No. 1 engine under cover sub-assembly from the vehicle body as shown in the illustration.



8. DRAIN ENGINE COOLANT


CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



A273797E01


Text in Illustration 
*1
Reservoir Cap
*2
Radiator Cap
*3
Radiator Drain Cock Plug
*4
Cylinder Block Drain Cock Plug (RH side)
  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap and drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the cylinder block drain cock plug and drain the coolant from the engine.



9. REMOVE V-BANK COVER


    A229925E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then detach the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
    Text in Illustration 
    *1
    Pin
    *2
    V-bank Cover Hook



10. REMOVE NO. 1 AIR CLEANER HOSE


    A221455
  1. Disconnect the ventilation hose and vacuum hose.

  1. Detach the wire harness clamp.

  1. Remove the bolt and loosen the 2 hose clamps.

  1. Remove the No. 1 air cleaner hose.



11. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    A075597E01
  1. Disconnect the No. 5 water by-pass hose.



    A075598E01
  1. Disconnect the No. 4 water by-pass hose.



    A075599E01
  1. Disconnect the throttle position sensor and throttle control motor connector.

  1. Remove the 4 bolts, throttle body with motor assembly and gasket.