Malfunctioning ECU
| Condition
| Procedure
| Refer to
|
Certification ECU
| Customer has brought all keys
| 1. Replace certification ECU
| -
|
2. Reregister all keys (new key ID registration)
| PROCEDURE "B"
|
Some keys are lost
| Key ID codes can be registered and cleared
| 1. Clear key codes (key ID erasure)
| PROCEDURE "D"
|
2. Perform additional key registration procedure (additional key ID registration)
| PROCEDURE "C"
|
3. Replace certification ECU
| -
|
4. Reregister all keys (new key ID registration)
- HINT:
- If some keys are not registered during above steps, they will be disabled because they cannot be registered later
| PROCEDURE "B"
|
Key ID codes cannot be either registered or cleared
| 1. Replace certification ECU
| -
|
2. Replace ID code box
| -
|
3. Reregister all keys (new key ID registration)
- HINT:
- If key codes cannot be cleared or additional keys cannot be registered due to malfunction in certification ECU, replace ID code box and certification ECU. If some keys are not registered during above steps, they will be disabled because they cannot be registered later.
| PROCEDURE "A"
|
4. ECU communication ID registration
| PROCEDURE "G"
|
Certification ECU
| All keys are lost
| 1. Replace certification ECU
| -
|
2. Replace ID code box
| -
|
3. Register all keys (new key ID registration)
- HINT:
- If key codes cannot be cleared or additional keys cannot be registered due to malfunction in certification ECU, replace ID code box and certification ECU. If some keys are not registered during above steps, they will be disabled because they cannot be registered later.
| PROCEDURE "A"
|
4. ECU communication ID registration
| PROCEDURE "G"
|
ID code box
| Customer has brought at least 1 key
| 1. Replace ID code box
| -
|
2. Register recognition codes in ECUs (ECU code registration)
| PROCEDURE "F"
|
3. ECU communication ID registration
| PROCEDURE "G"
|
All keys are lost
| 1. Replace certification ECU
| -
|
2. Replace ID code box
| -
|
3. Register all keys (new key ID registration)
- HINT:
- If some keys are not registered during above steps, they will be disabled because they cannot be registered later
| PROCEDURE "A"
|
4. ECU communication ID registration
| PROCEDURE "G"
|
Steering lock ECU
| Customer has brought at least 1 key
| 1. Replace steering lock ECU
| -
|
2. Register recognition codes in ECUs (ECU code registration)
| PROCEDURE "F"
|
All keys are lost
| 1. Replace certification ECU
| -
|
2. Replace ID code box
| -
|
3. Replace steering lock ECU
| -
|
4. Register all keys (new key ID registration)
| PROCEDURE "A"
|
5. ECU communication ID registration
| PROCEDURE "G"
|
Power management control ECU
| No condition required
| Replace power management control ECU
| -
|