Home › Engine / Hybrid System › 1GR-FE ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > DISASSEMBLY

for Preparation Click here



1. REMOVE INTAKE VALVE


    A221102E01
  1. Using SST, compress the inner compression spring and remove the valve spring retainer locks.

    SST
    09202-70020   (09202-00010)

  1. Remove the valve spring retainer, inner compression spring and intake valve.

    HINT:
    Arrange the removed parts in the correct order.



2. REMOVE EXHAUST VALVE


    A221103E01
  1. Using SST, compress the inner compression spring and remove the valve spring retainer locks.

    SST
    09202-70020   (09202-00010)

  1. Remove the valve spring retainer, inner compression spring and exhaust valve.

    HINT:
    Arrange the removed parts in the correct order.



3. REMOVE VALVE STEM OIL SEAL


    A221104
  1. Using needle-nose pliers, remove the valve stem oil seals.



4. REMOVE VALVE SPRING SEAT


    A221105
  1. Using compressed air and a magnet hand, remove the valve spring seats by blowing air onto them.



5. REMOVE NO. 1 STRAIGHT SCREW PLUG


    A221106E01
  1. Using a 10 mm hexagon wrench, remove the 4 No. 1 straight screw plugs and 4 gaskets.
    Text in Illustration 
    *A
    RH
    *B
    LH

    NOTICE:
    If coolant leaks from a straight screw plug or a plug is corroded, replace it.



6. REMOVE NO. 2 STRAIGHT SCREW PLUG


    A221107E01
  1. Using a 14 mm hexagon wrench, remove the 2 No. 2 straight screw plugs and 2 gaskets.
    Text in Illustration 
    *A
    RH
    *B
    LH

    NOTICE:
    If coolant leaks from a straight screw plug or a plug is corroded, replace it.



7. REMOVE STUD BOLT

NOTICE:
If a stud bolt is deformed or its threads are damaged, replace it.