CYLINDER HEAD > REASSEMBLY |
| 1. INSTALL STUD BOLT |
Using E6 and E8 "TORX" sockets, install the stud bolts.

| *A | Intake Side of RH | *B | Intake Side of LH |
| *C | Exhaust Side of RH | *D | Exhaust Side of LH |
| *E | Rear Side of RH | *F | Rear Side of LH |
| 2. INSTALL NO. 2 STRAIGHT SCREW PLUG |
Using a 14 mm hexagon wrench, install 2 new gaskets and the 2 No. 2 straight screw plugs.
| 3. INSTALL NO. 1 STRAIGHT SCREW PLUG |
Using a 10 mm hexagon wrench, install 4 new gaskets and the 4 No. 1 straight screw plugs.
| 4. INSTALL VALVE SPRING SEAT |
Install the valve spring seats to the cylinder head.
| 5. INSTALL VALVE STEM OIL SEAL |
![]() |
Apply a light coat of engine oil to new valve stem oil seals.
| *A | Intake Side |
| *B | Exhaust Side |
| *1 | Gray |
| *2 | Black |
![]() |
Using SST, push in the oil seals.
| *a | CORRECT |
| *b | INCORRECT |
| 6. INSTALL INTAKE VALVE |
![]() |
Apply a sufficient coat of engine oil to the tip area of the intake valve shown in the illustration.
Install the intake valve, inner compression spring and valve spring retainer to the cylinder head.
Using SST, compress the inner compression spring and install the 2 valve spring retainer locks.
![]() |
Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.
| 7. INSTALL EXHAUST VALVE |
![]() |
Apply a sufficient coat of engine oil to the tip area of the exhaust valve shown in the illustration.
Install the exhaust valve, inner compression spring and valve spring retainer to the cylinder head.
Using SST, compress the inner compression spring and install the 2 valve spring retainer locks.
![]() |
Using a plastic-faced hammer, lightly tap the valve stem tip to ensure a proper fit.