Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / (desired system) / Data List.

  5. According to the display on the Techstream, read the Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key Unlock Warning SW
    Unlock warning switch / ON or OFF
    ON: Key inserted into ignition key cylinder
    OFF: Key not inserted into ignition key cylinder
    -
    ACC SW
    Ignition switch status / ON or OFF
    ON: Ignition switch ACC
    OFF: Ignition switch off
    -
    IG SW
    Ignition switch status / ON or OFF
    ON: Ignition switch ON
    OFF: Ignition switch off
    -
    RR Door Courtesy SW
    Rear RH side door courtesy light switch signal / ON or OFF
    ON: Rear RH side door open
    OFF: Rear RH side door closed
    -
    RL Door Courtesy SW
    Rear LH side door courtesy light switch signal / ON or OFF
    ON: Rear LH side door open
    OFF: Rear LH side door closed
    -
    Back Door Open
    Back door lock position status / Permit or Prohibit
    Permit: Back door unlocked
    Prohibit: Back door locked
    -
    Door Key SW-Lock
    Door key linked lock switch signal / ON or OFF
    ON: Driver side door key cylinder turned to lock position
    OFF: Driver side door key cylinder not turned
    -
    D-Door Key SW-UL
    Door key linked unlock switch signal / ON or OFF
    ON: Driver side door key cylinder turned to unlock position
    OFF: Driver side door key cylinder not turned
    -
    FR Door Lock Pos
    Front RH side door lock position switch signal / UNLOCK or LOCK
    UNLOCK: Front RH side door unlocked
    LOCK: Front RH side door locked
    -
    FR Door Courtesy
    Front RH side door courtesy light switch signal / ON or OFF
    ON: Front RH side door closed
    OFF: Front RH side door open
    -
    FL Door Lock Pos
    Front LH side door lock position switch signal / UNLOCK or LOCK
    UNLOCK: Front LH side door unlocked
    LOCK: Front LH side door locked
    -
    FL Door Courtesy
    Front LH side door courtesy light switch signal / ON or OFF
    ON: Front LH side door closed
    OFF: Front LH side door open
    -
    Hood Courtesy SW
    Security courtesy switch / ON or OFF
    ON: Engine hood open
    OFF: Engine hood closed
    -
    RR-Door Lock Pos SW
    Rear RH side door lock position switch signal / ON or OFF
    ON: Rear RH side door unlocked
    OFF: Rear RH side door locked
    -
    RL-Door Lock Pos SW
    Rear LH side door lock position switch signal / ON or OFF
    ON: Rear LH side door unlocked
    OFF: Rear LH side door locked
    -

    Back Door P/W 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key Switch Operation Locked
    Tail gate control lock switch signal / ON or OFF
    ON: Back door key cylinder turned to lock position
    OFF: Back door key cylinder not turned
    -
    Key Switch Operation Unlocked
    Tail gate control unlock switch signal / ON or OFF
    ON: Back door key cylinder turned to unlock position
    OFF: Back door key cylinder not turned
    -
    Back Door Courtesy Switch
    Back door courtesy switch signal / ON or OFF
    ON: Back door open
    OFF: Back door closed
    -


ACTIVE TEST

HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / Main Body / Active Test.

  5. According to the display on the Techstream, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indicator
    Security indicator
    ON/OFF
    The test is possible when the following conditions are met:
    1. The key is in the cabin*1
    2. The engine switch on (IG)*1
    3. The key is in the ignition key cylinder*2
    Vehicle Horn
    Vehicle horn(s)
    ON/OFF
    -
    Security Horn
    Security Horn
    ON/OFF
    -

    1. *1: w/ Smart Key System
    2. *2: w/o Smart Key System