AUTOMATIC TRANSMISSION SYSTEM > MECHANICAL SYSTEM TESTS |
| STALL SPEED TEST |
Connect the Techstream to the DLC3.
Run the vehicle until the transmission fluid temperature is between 50 and 80°C (122 and 176°F).
Allow the engine to idle with the air conditioning off.
Chock all 4 wheels.
Set the parking brake and keep the brake pedal depressed firmly with your left foot.
Move the shift lever to D.
Depress the accelerator pedal as much as possible with your right foot.
Read the engine speed (stall speed) and release the accelerator pedal immediately.
| Test Result | Possible Cause |
| Stall speed is lower than standard value |
|
| Stall speed is higher than standard value |
|
| SHIFT TIME LAG TEST |
Connect the Techstream to the DLC3.
Run the vehicle until the transmission fluid temperature is between 50 and 80°C (122 and 176°F).
Allow the engine to idle with the air conditioning off.
Set the parking brake and keep the brake pedal depressed firmly.
Check the D position time lag.
Move the shift lever to N and wait for 1 minute.
Move the shift lever to D and measure the time until the shock is felt.
Repeat the 2 procedures above 3 times, and then calculate the average time of the 3 tests.
Check the R position time lag.
Move the shift lever to N and wait for 1 minute.
Move the shift lever to R and measure the time until the shock is felt.
Repeat the 2 procedures above 3 times, and then calculate the average time of the 3 tests.
| Test Result | Possible Cause |
| D position time lag exceeds standard value |
|
| R position time lag exceeds standard value |
|