Home › Vehicle Exterior › DOOR / HATCH › HOOD SUPPORT

HOOD SUPPORT > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL HOOD SUPPORT BRACKET LH


    B237110E02
  1. Install the hood support bracket with the 2 bolts in the order shown in the illustration.

    Torque:
    18 N*m{ 178 kgf*cm , 13 ft.*lbf }



2. INSTALL HOOD SUPPORT ASSEMBLY LH

NOTICE:
  1. Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing the vehicle.
  2. Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.
  3. In order to prevent the piston rod from deforming, do not apply any horizontal load to the door stay.



    B242389
  1. Install a new hood support assembly.

    NOTICE:
    Install a new hood support assembly while supporting the hood by hand.

  1. Check that the hood support assembly is attached to the ball joint and it cannot be pulled out.