Home › Vehicle Exterior › DOOR / HATCH › HOOD SUPPORT

HOOD SUPPORT > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE HOOD SUPPORT ASSEMBLY LH

NOTICE:
  1. Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing the vehicle.
  2. Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.
  3. In order to prevent the piston rod from deforming, do not apply any horizontal load to the door stay.



    B237109E01
  1. Using a screwdriver, remove the 2 stop rings as shown in the illustration, and then remove the hood support.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Remove the hood support assembly while supporting the hood panel with one hand.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE HOOD SUPPORT BRACKET LH


    B237110
  1. Remove the 2 bolts and hood support bracket.