SMART KEY SYSTEM (for Start Function) > SYSTEM DESCRIPTION |
| PUSH-BUTTON START DESCRIPTION |
The push-button start function uses a push-type engine switch, which the driver can operate by merely carrying the key. This system consists primarily of the power management control ECU, engine switch, ID code box, steering lock ECU, key, ACC relay, IG1 relay, IG2 relay and certification ECU. The power management control ECU controls the system. This function operates in cooperation with the smart key system.
| FUNCTION OF COMPONENT |
| Component | Function |
| Engine switch - Transponder key amplifier | Informs the driver of a power source mode or system abnormality with the illumination state of the indicator light. |
| Power management control ECU |
|
| Certification ECU |
|
| Stop light switch | Outputs the state of the brake pedal to the power management control ECU. |
| Park/neutral position switch | Outputs the state of the shift lever to the power management control ECU. |
| Shift lock control ECU | Outputs a shift lock control ECU signal to the power management control ECU. |
| ID code box |
|
| ECM |
|
| CONSTRUCTION AND OPERATION |
![]() |
| *1 | Indicator Light |
Engine Switch
The engine switch consists of a momentary type switch, color (amber, green) LEDs, and a transponder key amplifier.
Indicator Light Condition
| Power Source Mode/Condition | Indicator Light Condition | |
| Brake pedal released | Brake pedal depressed, shift lever in P or N | |
| Off | Off | Turns on (Green) |
| On (ACC) or on (IG) | Turns on (Amber) | Turns on (Green) |
| Engine running | Off | Off |
| Steering lock not unlocked | Flashes (Green) for 30 sec. | Flashes (Green) for 30 sec. |
| System malfunction | Flashes (Amber) for 15 sec. | Flashes (Amber) for 15 sec. |
Power Management Control ECU
The power management control ECU consists of the IG1 and IG2 relay actuation circuits and CPU.
| PUSH-BUTTON START FUNCTION OPERATION |
This system has different power source mode patterns depending on the brake pedal condition and shift lever position.
| Brake Pedal | Shift Lever Position | Power Source Mode Pattern |
| Depressed | P or N | When the engine switch is pushed once.
|
| Not depressed | P | Each time the engine switch is pushed.
|
| Except P | Each time the engine switch is pushed.
| |
| - | P | When the engine switch is on (IG) (engine running).
|
| - | Except P | When the engine switch is on (IG) (engine running).
|

| SYSTEM NOT OPERATING NORMALLY (DUE TO KEY BATTERY DEPLETION, ELECTRICAL NOISE, ETC.) |
![]() |
To operate the push-button start function when the key battery is low or the signal communication is affected by wave noise, hold the key against the engine switch with the brake pedal depressed.
| DIAGNOSIS |