Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Turn the ignition switch off.

  2. Connect the Techstream to the DLC3.

  3. Turn the ignition switch to ON.

  4. Turn the Techstream on.

  5. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

  6. According to the display on the Techstream, read the Data List.

    Tire Pressure Monitor 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Mode Status
    Tire pressure warning system mode/
    Normal or Test
    Normal: Normal mode
    Test: Test mode
    -
    Main Tire
    Number of IDs which can be registered/
    4 or 5
    4 displayed
    -
    2nd Tire
    -
    -
    -
    Main Tire
    Number of tire IDs to be registered/
    0, 1, 2, 3, 4 or 5
    0 to 4 displayed
    -
    2nd Tire
    -
    -
    -
    Select Switch
    -
    Main
    -
    Vehicle Speed
    Vehicle speed reading/
    min.: 0 km/h (0 mph)
    max.: 255 km/h (158 mph)
    Actual vehicle speed
    The speed indicated on the combination meter.
    Registered ID1 Code
    Registered ID1 code/
    min.: 0
    max.: FFFFFFF*1
    ID No. registered in transmitter ID1 displayed
    -
    Registered ID2 Code
    Registered ID2 code/
    min.: 0
    max.: FFFFFFF*1
    ID No. registered in transmitter ID2 displayed
    -
    Registered ID3 Code
    Registered ID3 code/
    min.: 0
    max.: FFFFFFF*1
    ID No. registered in transmitter ID3 displayed
    -
    Registered ID4 Code
    Registered ID4 code/
    min.: 0
    max.: FFFFFFF*1
    ID No. registered in transmitter ID4 displayed
    -
    Registered ID5 Code
    Registered ID5 code/
    min.: 0
    max.: FFFFFFF*1
    -
    -
    ID Transmission Status
    ID transmission status/
    Finish or Now
    Finish or Now
    -
    Initialization Switch
    -
    OFF
    -
    ID1 Tire Inflation Pressure
    ID1 tire inflation pressure/
    min.: Absolute pressure 0.0 kPa (0.0 kgf/cm2, 0.0 psi), Relative pressure -100.0 kPa (-1.0 kgf/cm2, -14 psi)
    max.: Absolute pressure 637.5 kPa (6.5 kgf/cm2, 92 psi), Relative pressure 537.5 kPa (5.4 kgf/cm2, 78 psi)
    Actual tire inflation pressure
    If 0 kPa (0.0 kgf/cm2, 0.0 psi) is displayed for absolute pressure or -100 kPa (-1.0 kgf/cm2, -14 psi) is displayed for relative pressure, data has not been received.*2
    ID2 Tire Inflation Pressure
    ID2 tire inflation pressure/
    min.: Absolute pressure 0.0 kPa (0.0 kgf/cm2, 0.0 psi), Relative pressure -100.0 kPa (-1.0 kgf/cm2, -14 psi)
    max.: Absolute pressure 637.5 kPa (6.5 kgf/cm2, 92 psi), Relative pressure 537.5 kPa (5.4 kgf/cm2, 78 psi)
    Actual tire inflation pressure
    If 0 kPa (0.0 kgf/cm2, 0.0 psi) is displayed for absolute pressure or -100 kPa (-1.0 kgf/cm2, -14 psi) is displayed for relative pressure, data has not been received.*2
    ID3 Tire Inflation Pressure
    ID3 tire inflation pressure/
    min.: Absolute pressure 0.0 kPa (0.0 kgf/cm2, 0.0 psi), Relative pressure -100.0 kPa (-1.0 kgf/cm2, -14 psi)
    max.: Absolute pressure 637.5 kPa (6.5 kgf/cm2, 92 psi), Relative pressure 537.5 kPa (5.4 kgf/cm2, 78 psi)
    Actual tire inflation pressure
    If 0 kPa (0.0 kgf/cm2, 0.0 psi) is displayed for absolute pressure or -100 kPa (-1.0 kgf/cm2, -14 psi) is displayed for relative pressure, data has not been received.*2
    ID4 Tire Inflation Pressure
    ID4 tire inflation pressure/
    min.: Absolute pressure 0.0 kPa (0.0 kgf/cm2, 0.0 psi), Relative pressure -100.0 kPa (-1.0 kgf/cm2, -14 psi)
    max.: Absolute pressure 637.5 kPa (6.5 kgf/cm2, 92 psi), Relative pressure 537.5 kPa (5.4 kgf/cm2, 78 psi)
    Actual tire inflation pressure
    If 0 kPa (0.0 kgf/cm2, 0.0 psi) is displayed for absolute pressure or -100 kPa (-1.0 kgf/cm2, -14 psi) is displayed for relative pressure, data has not been received.*2
    ID5 Tire Inflation Pressure
    ID5 tire inflation pressure/
    min.: Absolute pressure 0.0 kPa (0.0 kgf/cm2, 0.0 psi), Relative pressure -100.0 kPa (-1.0 kgf/cm2, -14 psi)
    max.: Absolute pressure 637.5 kPa (6.5 kgf/cm2, 92 psi), Relative pressure 537.5 kPa (5.4 kgf/cm2, 78 psi)
    -
    -
    ID1 Temperature in Tire
    ID1 temperature in tire/
    min.: -40°C (-40°F)
    max.: 215°C (419°F)
    Actual tire temperature
    If -40°C (-40°F) is displayed, the data has not been received.
    ID2 Temperature in Tire
    ID2 temperature in tire/
    min.: -40°C (-40°F)
    max.: 215°C (419°F)
    Actual tire temperature
    If -40°C (-40°F) is displayed, the data has not been received.
    ID3 Temperature in Tire
    ID3 temperature in tire/
    min.: -40°C (-40°F)
    max.: 215°C (419°F)
    Actual tire temperature
    If -40°C (-40°F) is displayed, the data has not been received.
    ID4 Temperature in Tire
    ID4 temperature in tire/
    min.: -40°C (-40°F)
    max.: 215°C (419°F)
    Actual tire temperature
    If -40°C (-40°F) is displayed, the data has not been received.
    ID5 Temperature in Tire
    ID5 temperature in tire/
    min.: -40°C (-40°F)
    max.: 215°C (419°F)
    -
    -
    ID1 Battery Voltage
    ID1 battery voltage/
    Over or Less
    Over
    -
    ID2 Battery Voltage
    ID2 battery voltage/
    Over or Less
    Over
    -
    ID3 Battery Voltage
    ID3 battery voltage/
    Over or Less
    Over
    -
    ID4 Battery Voltage
    ID4 battery voltage/
    Over or Less
    Over
    -
    ID5 Battery Voltage
    ID5 battery voltage/
    Over or Less
    -
    -
    Select SW Info
    Tire pressure warning select switch setting information/
    With or Without
    Without
    -
    Initialization SW Info
    Tire pressure warning reset switch setting information/
    With or Without
    Without
    -
    ID1 Initial Threshold of Low-pressure
    ID1 initial threshold of low pressure/
    min.: -100.0 kPa (-1.0 kgf/cm2, -14 psi)
    max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
    -
    -
    ID2 Initial Threshold of Low-pressure
    ID2 initial threshold of low pressure/
    min.: -100.0 kPa (-1.0 kgf/cm2, -14 psi)
    max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
    -
    -
    ID3 Initial Threshold of Low-pressure
    ID3 initial threshold of low pressure/
    min.: -100.0 kPa (-1.0 kgf/cm2, -14 psi)
    max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
    -
    -
    ID4 Initial Threshold of Low-pressure
    ID4 initial threshold of low pressure/
    min.: -100.0 kPa (-1.0 kgf/cm2, -14 psi)
    max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
    -
    -
    ID5 Initial Threshold of Low-pressure
    ID5 initial threshold of low pressure/
    min.: -100.0 kPa (-1.0 kgf/cm2, -14 psi)
    max.: 537.5 kPa (5.4 kgf/cm2, 78 psi)
    -
    -
    Engine Speed
    Engine speed reading/
    min.: 0 rpm
    max.: 65535 rpm
    Actual engine speed
    The engine speed indicated on the combination meter.
    Number of Trouble Code
    Number of trouble codes stored/
    min.: 0
    max.: 255
    0
    -

    HINT:
    1. *1: Displayed only when the ID No. is not registered.
    2. *2: It may take approximately 2 or 3 minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2124/24 (Click here).


PERFORM ACTIVE TEST
  1. Turn the ignition switch off.

  2. Connect the Techstream to the DLC3.

  3. Turn the ignition switch to ON.

  4. Turn the Techstream on.

  5. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  6. According to the display on the Techstream, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Tire Pressure Warning System
    Tire Pressure Warning Light
    ON / OFF
    Confirm that the vehicle is stopped with the engine idling.