RADIATOR > ON-VEHICLE INSPECTION |
| 1. INSPECT RADIATOR CAP SUB-ASSEMBLY |
![]() |
Measure the valve opening pressure.
If there are water stains or foreign matter on rubber packing 1, 2 or 3, clean it by using water and finger scouring.
Check that rubber packing 1, 2 and 3 are not deformed, cracked or swollen.
Check that rubber packing 3 and 4 are not stuck together.
Apply engine coolant to rubber packing 2 and 3.
![]() |
When using the cap tester, tilt it more than 30°.
| *1 | Radiator Cap |
| *2 | Radiator Cap Tester |
| *a | More than 30° |
Pump the cap tester several times and check the maximum pressure.*1
| Item | Specified Condition |
| Standard Value (for brand-new cap) | 93 to 123 kPa (1.0 to 1.3 kgf/cm2, 13.5 to 18 psi) |
| Minimum Standard Value (for used cap) | 79 kPa (0.8 kgf/cm2, 11.4 psi) |
| 2. INSPECT FINS FOR BLOCKAGE |
![]() |
If the fins are clogged, wash them with water or a steam cleaner and dry them with compressed air.
| Injection Pressure | Specified Condition |
| 2942 to 4903 kPa (30.0 to 50.0 kgf/cm2, 427 to 711 psi) | 300 mm (11.8 in.) |
| 4903 to 7845 kPa (50.0 to 80.0 kgf/cm2, 711 to 1138 psi) | 500 mm (19.7 in.) |
Dry the fins with compressed air.