Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART KEY SYSTEM (for Start Function)

SMART KEY SYSTEM (for Start Function) > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC
  1. Connect the Techstream to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / (desired system) / Trouble Codes.

  5. Check for DTCs.

    HINT:
    Refer to the Techstream operator's manual for further details.


CLEAR DTC
  1. Connect the Techstream to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the Techstream on.

  4. Enter the following menus: Body Electrical / (desired system) / Trouble Codes.

  5. Clear the DTCs by following the directions on the Techstream display.

    HINT:
    Refer to the Techstream operator's manual for further details.