Home › Engine / Hybrid System › 1GR-FE STARTING › IGNITION SWITCH

IGNITION SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL IGNITION SWITCH ASSEMBLY
  1. Attach the claw to connect the key interlock solenoid wire harness to the ignition switch.

  1. Install the ignition switch with the 2 screws.

  1. Connect the ignition switch connector and key interlock solenoid connector and attach the wire harness clamp.



2. INSTALL LOWER STEERING COLUMN COVER
  1. Attach the 2 claws to install the lower steering column cover.

  1. Install the 2 screws.

    HINT:
    Turn the steering wheel to the right and left as necessary to install the 2 screws.