TRANSFER ASSEMBLY > INSPECTION |
| 1. INSPECT TRANSFER INPUT SHAFT |
![]() |
Using a micrometer, measure the diameter of the input shaft journal.
![]() |
Using a dial indicator, measure the inside diameter of the input shaft bushing.
| 2. INSPECT PLANETARY PINION GEAR THRUST CLEARANCE |
![]() |
Using a feeler gauge, measure the thrust clearance of the pinion gear.
| 3. INSPECT PLANETARY PINION GEAR RADIAL CLEARANCE |
![]() |
Using a dial indicator, measure the radial clearance of the pinion gear.
| 4. INSPECT TRANSFER DRIVE SPROCKET THRUST CLEARANCE |
![]() |
Using a feeler gauge, measure the thrust clearance.
| 5. INSPECT REAR TRANSFER OUTPUT SHAFT |
![]() |
Using a micrometer, measure the diameter of the output shaft journal.
| Journal | Specified Condition |
| A | 27.98 mm (1.102 in.) |
| B | 36.98 mm (1.457 in.) |
| 6. INSPECT TRANSFER DRIVE SPROCKET RADIAL CLEARANCE |
![]() |
Using a dial indicator, measure the radial clearance between the drive sprocket and output shaft with the needle roller bearing installed.
| 7. INSPECT TRANSFER HIGH AND LOW CLUTCH SLEEVE AND NO. 2 TRANSFER GEAR SHIFT FORK CLEARANCE |
![]() |
Using a feeler gauge, measure the clearance between the clutch sleeve and No. 2 gear shift fork.
| 8. INSPECT FRONT DRIVE CLUTCH SLEEVE AND NO. 1 TRANSFER GEAR SHIFT FORK CLEARANCE |
![]() |
Using a feeler gauge, measure the clearance between the clutch sleeve and No. 1 gear shift fork.