Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > TERMINALS OF ECU

for Preparation Click here



RADIO AND DISPLAY RECEIVER ASSEMBLY
#: There is no wire color information.

E283445E04


Terminal No. (Symbols)
Wiring Color
Terminal Description
Condition
Specification
G48-1 (FR+) - G48-7 (GND)
P - BR
Sound signal (Front Right)
Audio system playing
A waveform synchronized with sounds is output
G48-2 (FL+) - G48-7 (GND)
LG - BR
Sound signal (Front Left)
Audio system playing
A waveform synchronized with sounds is output
G48-3 (ACC) - G48-7 (GND)
GR - BR
Power source (ACC)
Ignition switch off
Below 1 V
Ignition switch ACC
11 to 14 V
G48-4 (B) - G48-7 (GND)
SB - BR
Power source (+B)
Always
11 to 14 V
G48-5 (FR-) - G48-7 (GND)
Y - BR
Sound signal (Front Right)
Audio system playing
A waveform synchronized with sounds is output
G48-6 (FL-) - G48-7 (GND)
L - BR
Sound signal (Front Left)
Audio system playing
A waveform synchronized with sounds is output
G48-7 (GND) - Body ground
BR - Body ground
Ground
Always
Below 1 V
G48-10 (ILL+) - G48-7 (GND)
G - BR
Illumination signal
Light control switch off
Below 1 V
Light control switch in tail or head position
11 to 14 V
G47-1 (RR+) - G48-7 (GND)
R - BR
Sound signal (Rear Right)
Audio system playing
A waveform synchronized with sounds is output
G47-2 (RL+) - G48-7 (GND)
B - BR
Sound signal (Rear Left)
Audio system playing
A waveform synchronized with sounds is output
G47-3 (RR-) - G48-7 (GND)
W - BR
Sound signal (Rear Right)
Audio system playing
A waveform synchronized with sounds is output
G47-5 (ILL-) - G48-7 (GND)
W - BR
Illumination signal
Ignition switch off
Below 1 V
Light control switch in tail or head position
Pulse generation
G47-6 (RL-) - G48-7 (GND)
Y - BR
Sound signal (Rear Left)
Audio system playing
A waveform synchronized with sounds is output
G49-1 (IG) - G48-7 (GND)
L - BR
Power source (IG)
Ignition switch off
Below 1 V
Ignition switch ON
11 to 14 V
G49-2 (REV) - G48-7 (GND)
R - BR
Reverse signal
See "Vehicle Signal Check Mode" in Operation Check (Click here)
-
G49-4 (MACC) - G48-7 (GND)
R - BR
Microphone power supply
Ignition switch off
Below 1 V
Ignition switch ACC
4 to 6 V
G49-5 (MIN+) - G48-7 (GND)
B - BR
Microphone voice signal
See "Check Microphone" in Operation Check (Click here)
-
G49-6 (SNS2) - G48-7 (GND)
G - BR
Microphone connection detection signal
Always
Below 1 V
G49-9 (CANH)
P
CAN communication signal
-
-
G49-10 (CANL)
W
CAN communication signal
-
-
G49-11 (AGND) - Body ground
Shield - Body ground
Shield ground
Always
Below 1 V
G49-12 (SG) - G48-7 (GND)
Shield - BR
External device connection detection signal
Always
Below 1 V
G49-13 (VV+) - G48-7 (GND)
B - BR
Video signal
External device playing (When stereo jack used)
A waveform synchronized with video signals is output
G49-14 (VV-) - G48-7 (GND)
W - BR
Video signal
External device playing (When stereo jack used)
A waveform synchronized with video signals is output
G49-15 (PKB) - G48-7 (GND)
LG - BR
Parking Bake signal
See "Vehicle Signal Check Mode" in Operation Check (Click here)
-
G49-17 (SPD) - G48-7 (GND)
SB - BR
Vehicle speed signal
See "Vehicle Signal Check Mode" in Operation Check (Click here)
-
G49-18 (SGND) - Body ground
Shield - Body ground
Shield ground
Always
Below 1 V
G49-19 (MIN-) - G48-7 (GND)
W - BR
Microphone voice signal
See "Check Microphone" in Operation Check (Click here)
-
G49-21 (SW1) - G49-23 (SWG)
W - L
Steering pad switch signal
No switch pushed
2.97 to 3.56 V
Up switch pushed
0.27 to 0.35 V
Down switch pushed
0.86 to 1.03 V
Volume+ switch pushed
1.51 to 1.79 V
Volume- switch pushed
2.22 to 2.66 V
G49-22 (SW2) - G49-23 (SWG)
R - L
Steering pad switch signal
No switch pushed
2.97 to 3.56 V
MODE/HOLD switch pushed
0.27 to 0.35 V
On hook switch pushed
0.86 to 1.03 V
Off hook switch pushed
1.51 to 1.79 V
Voice switch pushed
2.22 to 2.66 V
G49-23 (SWG) - Body ground
L - Body ground
Steering pad switch ground
Always
Below 1 V
G49-24 (SW3) - G49-23 (SWG)
P - L
Steering pad switch signal
No switch pushed
2.97 to 3.56 V
Enter switch pushed
0.27 to 0.35 V
Back switch pushed
0.86 to 1.03 V
Right switch pushed
1.51 to 1.79 V
Left switch pushed
2.22 to 2.66 V
G49-25 (ADPG) - G48-7 (GND)
V - BR
External device connection detection signal
External device connected
Below 1 V
External device not connected
2.1 to 3 V
G49-26 (VAR+) - G49-27 (VA-)
R - W
Sound signal (Right)
External device playing (When stereo jack used)
A waveform synchronized with sounds is output
G49-27 (VA-) - G48-7 (GND)
W - BR
Ground
Always
Below 1 V
G49-28 (VAL+) - G49-27 (VA-)
B - W
Sound signal (Left)
External device playing (When stereo jack used)
A waveform synchronized with sounds is output
G50-11 (CA+) - G48-7 (GND)
R - BR
Television camera power supply
Ignition switch ON
Shift lever in R
5.5 to 7.05 V
G50-12 (V+) - G48-7 (GND)
W - BR
Video signal
Ignition switch ON
Shift lever in R
Camera lens not covered, displaying an image
Pulse generation
(Refer to waveform 1)
Ignition switch ON
Shift lever in R
Camera lens covered, blacking out screen
Pulse generation
(Refer to waveform 2)
G50-23 (CGND) - Body ground
Shield - Body ground
Shield ground
Always
Below 1 V
G50-24 (V-) - G48-7 (GND)
B - BR
Ground
Always
Below 1 V
G51-1 (USV1)
#
Power source
-
-
G51-2 (US1-)
#
Data signal
-
-
G51-3 (US1+)
#
Data signal
-
-
G51-4 (UGD1)
#
Ground
-
-
G51-5 (USG1)
#
Shield ground
-
-
G52-1 (FMSUB1)
#
Radio SUB signal
-
-
G52-2 (R+B1) - G48-7 (GND)
# - BR
Power source of antenna
Ignition switch ACC
Radio switch on and FM or AM selected
11 to 14 V
G52-3 (AMFM1)
#
Radio MAIN signal
-
-


    E171712E20
  1. Reference (Oscilloscope waveform):

    1. Waveform 1 (camera lens not covered, displaying an image)
      Item
      Content
      Measurement terminal
      G50-12 (V+) - G48-7 (GND)
      Measurement setting
      200 mV/DIV., 50 μsec./DIV.
      Condition
      Ignition switch ON, Shift lever in R

      HINT:
      The video waveform changes according to the image sent by the television camera assembly.

    2. Waveform 2 (camera lens covered, blacking out the screen)
      Item
      Content
      Measurement terminal
      G50-12 (V+) - G48-7 (GND)
      Measurement setting
      200 mV/DIV., 50 μsec./DIV.
      Condition
      Ignition switch ON, Shift lever in R

      HINT:
      The video waveform changes according to the image sent by the rear television camera assembly.

      Text in Illustration 
      *a
      Waveform 1 (camera lens not covered, displaying an image)
      *b
      Waveform 2 (camera lens covered, blacking out the screen)
      *c
      Synchronization Signal
      *d
      Video Waveform