AUDIO AND VISUAL SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC (CHECK USING TECHSTREAM) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
Check for DTCs, and then write them down.
Check the details of the DTC(s) (Click here).
| CLEAR DTC (CLEAR USING TECHSTREAM) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
Clear the DTCs.
| START DIAGNOSTIC MODE |
Turn the ignition switch to ON.
While pressing and holding the "Audio" switch, operate the light control switch: Off → Tail → Off → Tail → Off → Tail → Off.
Diagnostic mode starts and the "Service Menu" screen will be displayed. Service inspection starts automatically and the result will be displayed.
| FAILURE DIAGNOSIS |
![]() |
The "Failure Diagnosis" screen will be displayed by pressing the "Failure Diagnosis" switch on the "Service Menu" screen.
| SYSTEM CHECK |
![]() |
The "System Check Mode" screen will be displayed by pressing the "System Check" switch on the "Failure Diagnosis" screen.
| CHECK DTC (CHECK USING SYSTEM CHECK MODE SCREEN) |
![]() |
System check mode screen description
| Display | Content |
| *a: Device Name List No. 1 |
|
| *b: Check Result | Result codes for all devices are displayed. |
| *c: Memory Clear |
|
| *d: Recheck |
|
| *e: Device Name List No. 2 |
|
| Name | Component | Connection Method |
| DA | Radio and display receiver assembly | - |
| Result | Meaning | Action |
| DETAIL | The device responds with a DTC. | Look up the DTC in "Unit Check Mode". |
| Name | Component | Connection Method |
| AUX/VTR | No. 1 stereo jack adapter assembly | Vehicle wire harness |
![]() |
Unit check mode screen description
| Display | Content |
| *a: Device name | Target device |
| *b: History DTC | Diagnostic memory results and stored DTCs are displayed. |
| *c: Current DTC | DTCs output in the service check are displayed. |
| *d: DTC | DTC (Diagnostic Trouble Code) |
| *e: Diagnosis clear switch | Pushing this switch for 3 seconds clears the diagnostic memory data of the target device (Both response to diagnostic system check result and the displayed data are cleared.). |
Read the system check result.
![]() |
If the check result is "DETAIL", touch the displayed check result to view the results on the "Unit Check Mode" screen and record them.
![]() |
Check the details of the DTC(s) (Click here).
| DTC CLEAR/RECHECK (CLEAR USING SYSTEM CHECK MODE SCREEN) |
![]() |
Clear DTCs
Press the "Memory CLR" switch for 3 seconds.
Confirm that the check results are cleared.
![]() |
Recheck
Press the "Recheck" switch.
![]() |
Confirm that all diagnostic codes are "OK" when the check results are displayed. If a code other than "OK" is displayed, troubleshoot again.
| FINISH DIAGNOSTIC MODE |
Turn the ignition switch off.